KPLAYER 2500 HDMI NO SIGNAL SERIES
KPLAYER 2500 HDMI NO SIGNAL TV

I found a thread where people are replacing capacitors themselves. The issue seems to be capacitors failing on the HDMI board, probably due to extended exposure to heat.

KPLAYER 2500 HDMI NO SIGNAL SERIES

A lot more people have the 5xx and 6xx series so there are a lot more complaints about those models. I wonder if the issue probably impacts the same percentage of all models. Most threads are specific to the lower end receivers (5xx and 6xx series) but searching those threads for '906' did reveal similar issues with the higher end models. This morning I expanded my search to just Onkyo HDMI issues and got a lot of hits. It was getting late so I figured I'd start another thread to see if I got any hits. My searches last night were specific to the TX-NR-906. I looked a little last night before posting but didn't find much. Is there anyone else that has experienced this with an Onkyo TX-NR906? It's almost like the HDMI board just failed unfortunately right now that's the only thing that makes any sense. But then today, the HDMI doesn't seem to work no matter what I do. The last change I made to the system was adding the OPPO Blu Ray player just after Christmas it has worked fine since I hooked it up. I have swapped out new source components, but have never experienced any HDMI issues in the past. I did a factory reset of the receiver and tried everything again, nothing.ДЄgain I have had this receiver for three years and never had a problem. I switched to the second HDMI monitor out in the menu and moved the cable in back to the second HDMI out, nothing. I tried bringing up the Onkyo's set up menu, nothing.

KPLAYER 2500 HDMI NO SIGNAL TV

I connected both the Sat Receiver and Blu Ray directly to the TV and they both worked fine. I then switched to my OPPO Blu Ray and same thing 'No Signal'. But today turning off and on didn't correct the issue. Today I went to watch TV and same thing as yesterday, all components on but display reads 'No Signal' from the HDMI. I turned the 906 off and back on and it worked for the rest of the night. This had NEVER happened even once before. The 906 was set to the correct input, but the display on the front of the 906 said 'No Signal'.

I confirmed that my TV, Sat Receiver, and 906 were all powered on. Yesterday I turned my system on to watch TV and a picture never appeared, just a black screen. I've had my TX-NR906 for almost three years without ever experiencing an issue.

Kplayer 2500 hdmi no signal